GATE 2015 ME Set 2 · Question 63
A resistance-capacitance relaxation circuit is used in an electrical discharge machining process. The discharge voltage is . At a spark cycle time of , the average power input required is . The capacitance (in ) in the circuit is
- A
2.5
- B
5.0
- C
7.5
- D
10.0
GATE 2015 · Mechanical Engineering · Set 2 · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
In an RC relaxation circuit for electrical discharge machining (EDM), the energy delivered per spark is equal to the energy stored in the capacitor at the discharge voltage :
The average power input over a spark cycle time is given by:
Substitute the given parameters (, , ):
Answer: (B) 5.0
Practise Non-Traditional Machining (NTM) Processes
23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Non-Traditional Machining (NTM) Processes
- GATE 2014 ME Set 2 · Q33The following four unconventional machining processes are available in a shop floor. The most appropriate…
- GATE 2014 ME Set 3 · Q28The process utilizing mainly thermal energy for removing material is
- GATE 2014 ME Set 4 · Q32The principle of material removal in Electrochemical machining is
- GATE 2013 ME · Q38During the electrochemical machining (ECM) of iron (atomic weight = 56, valency = 2) at current of 1000 A…
- GATE 2012 ME · Q1In abrasive jet machining, as the distance between the nozzle tip and the work surface increases, the…
- GATE 2025 ME · Q24Ceramics and glass are machined by
Question from the official GATE 2015 ME paper (Set 2), IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.