GATE 2012 ME · Question 1
In abrasive jet machining, as the distance between the nozzle tip and the work surface increases, the material removal rate
- A
increases continuously.
- B
decreases continuously.
- C
decreases, becomes stable and then increases.
- D
increases, becomes stable and then decreases.
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
In Abrasive Jet Machining (AJM), the distance between the nozzle tip and the work surface is known as the stand-off distance (SOD) or nozzle tip distance (NTD).
1. At very small stand-off distances, the abrasive particles do not have sufficient space to accelerate to their maximum velocity, and the spent abrasive particles hinder fresh incoming particles, resulting in a lower Material Removal Rate (MRR).
2. As the stand-off distance increases, the abrasive jet accelerates and expands, increasing the kinetic energy and flaring of the jet, which causes the MRR to increase and reach a relatively stable maximum plateau.
3. Beyond the optimum distance, the velocity of the abrasive particles drops significantly due to air drag, and the jet diverges excessively, leading to a decrease in MRR.
Therefore, as the distance increases, the MRR increases, becomes stable, and then decreases.
Answer: (D)
Practise Non-Traditional Machining (NTM) Processes
23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Non-Traditional Machining (NTM) Processes
- GATE 2025 ME · Q24Ceramics and glass are machined by
- GATE 2022 ME Set 1 · Q33Electrochemical machining operations are performed with tungsten as the tool, and copper and aluminum as two…
- GATE 2022 ME Set 2 · Q28Which of these processes involve(s) melting in metallic workpieces?
- GATE 2021 ME Set 2 · Q17The machining process that involves ablation is
- GATE 2020 ME Set 1 · Q54A steel part with surface area of 125 cm2 is to be chrome coated through an electroplating process using…
- GATE 2020 ME Set 2 · Q19The process, that uses a tapered horn to amplify and focus the mechanical energy for machining of glass, is
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.