GATE 2016 ME Set 1 · Question 22
The spring constant of a helical compression spring DOES NOT depend on
- A
coil diameter
- B
material strength
- C
number of active turns
- D
wire diameter
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.12 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The stiffness (spring constant) of a helical compression spring is given by:
where:
- is the shear modulus of elasticity (an elastic property, not a strength property),
- is the wire diameter,
- is the mean coil diameter,
- is the number of active turns.
Hence, the spring constant depends directly on the geometry () and the elastic modulus . It is independent of the material strength (such as yield strength or ultimate tensile strength), which only dictates the load-carrying capacity before failure.
Answer: (B) material strength
Practise Springs
6 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Springs
- GATE 2026 ME · Q19A closely coiled helical compression spring of mean coil diameter D and wire diameter d, is loaded by an…
- GATE 2021 ME Set 1 · Q29Shear stress distribution on the cross-section of the coil wire in a helical compression spring is shown in…
- GATE 2020 ME Set 2 · Q41A helical spring has spring constant k. If the wire diameter, spring diameter and the number of coils are…
- GATE 2018 ME Set 1 · Q31If the wire diameter of a compressive helical spring is increased by 2%, the change in spring stiffness (in…
- GATE 2017 ME Set 2 · Q33A helical compression spring made of a wire of circular cross-section is subjected to a compressive load.…
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.