GATE 2021 ME Set 1 · Question 29
Shear stress distribution on the cross-section of the coil wire in a helical compression spring is shown in the figure. This shear stress distribution represents
- A
direct shear stress in the coil wire cross-section
- B
torsional shear stress in the coil wire cross-section
- C
combined direct shear and torsional shear stress in the coil wire cross-section
- D
combined direct shear and torsional shear stress along with the effect of stress concentration at inside edge of the coil wire cross-section
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.19 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
In a helical compression spring, the wire is subjected to two primary stresses:
1. Torsional shear stress (): It varies linearly from zero at the central axis of the wire cross-section to a maximum at the outer fibers, acting in opposite directions on opposite sides of the diameter:
2. Direct (transverse) shear stress (): It is typically assumed to be uniformly distributed across the cross-section in the direction of the applied load:
Superimposing these two gives a straight-line distribution that is shifted upward:
At the center, the shear stress is non-zero (). At the inner edge of the coil, the two stresses add together, while at the outer edge, they oppose each other.
Since the distribution remains strictly linear across the diameter, the effect of curvature and stress concentration (the Wahl factor) is not included (which would otherwise introduce a non-linear, hyperbolic profile near the inner fiber).
Answer: (C) combined direct shear and torsional shear stress in the coil wire cross-section
Practise Springs
6 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Springs
- GATE 2020 ME Set 2 · Q41A helical spring has spring constant k. If the wire diameter, spring diameter and the number of coils are…
- GATE 2018 ME Set 1 · Q31If the wire diameter of a compressive helical spring is increased by 2%, the change in spring stiffness (in…
- GATE 2017 ME Set 2 · Q33A helical compression spring made of a wire of circular cross-section is subjected to a compressive load.…
- GATE 2016 ME Set 1 · Q22The spring constant of a helical compression spring DOES NOT depend on
- GATE 2026 ME · Q19A closely coiled helical compression spring of mean coil diameter D and wire diameter d, is loaded by an…
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.