GATE 2017 ME Set 2 · Question 33
A helical compression spring made of a wire of circular cross-section is subjected to a compressive load. The maximum shear stress induced in the cross-section of the wire is . For the same compressive load, if both the wire diameter and the mean coil diameter are doubled, the maximum shear stress (in MPa) induced in the cross-section of the wire is ________
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The maximum shear stress in a helical compression spring is given by
where is the axial compressive load, is the mean coil diameter, is the wire diameter, and is the Wahl stress factor which depends only on the spring index .
When both and are doubled:
The spring index remains unchanged:
For the same load , the ratio of maximum shear stresses is
Given :
Answer: 6
Practise Springs
6 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Springs
- GATE 2016 ME Set 1 · Q22The spring constant of a helical compression spring DOES NOT depend on
- GATE 2026 ME · Q19A closely coiled helical compression spring of mean coil diameter D and wire diameter d, is loaded by an…
- GATE 2021 ME Set 1 · Q29Shear stress distribution on the cross-section of the coil wire in a helical compression spring is shown in…
- GATE 2020 ME Set 2 · Q41A helical spring has spring constant k. If the wire diameter, spring diameter and the number of coils are…
- GATE 2018 ME Set 1 · Q31If the wire diameter of a compressive helical spring is increased by 2%, the change in spring stiffness (in…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.