GATE 2016 ME Set 1 · Question 48
The principal stresses at a point inside a solid object are , and . The yield strength of the material is . The factor of safety calculated using Tresca (maximum shear stress) theory is and the factor of safety calculated using von Mises (maximum distortional energy) theory is . Which one of the following relations is TRUE?
- A
- B
- C
- D
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.38 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The given principal stresses are , , and . The yield strength is .
1. Tresca Theory (Maximum Shear Stress Theory):
Failure occurs when :
2. von Mises Theory (Distortion Energy Theory):
The equivalent stress is:
The factor of safety is:
Therefore, .
Answer: (C)
Practise Design for Static Loading & Failure Theories
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Static Loading & Failure Theories
- GATE 2014 ME Set 4 · Q40A shaft is subjected to pure torsional moment. The maximum shear stress developed in the shaft is 100 MPa.…
- GATE 2024 ME · Q56A solid massless cylindrical member of 50 mm diameter is rigidly attached at one end, and is subjected to an…
- GATE 2019 ME Set 1 · Q52At a critical point in a component, the state of stress is given as σxx = 100 MPa, σyy = 220 MPa, σxy = σyx…
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.