GATE 2024 ME · Question 56
A solid massless cylindrical member of diameter is rigidly attached at one end, and is subjected to an axial force and a torque at the other end as shown. Assume that the axis of the cylinder is normal to the support. Considering distortion energy theory with allowable yield stress as , the factor of safety in the design is _____________ *(rounded off to 1 decimal place)*.
GATE 2024 · Mechanical Engineering · IISc Bangalore
Answer
From the official answer key published by IISc Bangalore.
Worked solution
For a solid circular cross-section with diameter :
- Cross-sectional area:
- Polar section modulus:
The normal stress due to axial force is:
The maximum shear stress due to torque is:
According to the distortion energy (von Mises) theory, the equivalent stress is:
With allowable yield strength , the factor of safety is:
Answer: 4.5
Practise Design for Static Loading & Failure Theories
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Static Loading & Failure Theories
- GATE 2019 ME Set 1 · Q52At a critical point in a component, the state of stress is given as σxx = 100 MPa, σyy = 220 MPa, σxy = σyx…
- GATE 2016 ME Set 1 · Q48The principal stresses at a point inside a solid object are σ1 = 100 MPa, σ2 = 100 MPa and σ3 = 0 MPa. The…
- GATE 2014 ME Set 4 · Q40A shaft is subjected to pure torsional moment. The maximum shear stress developed in the shaft is 100 MPa.…
Question from the official GATE 2024 ME paper, IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.