GATE 2019 ME Set 1 · Question 52
At a critical point in a component, the state of stress is given as , , and all other stress components are zero. The yield strength of the material is . The factor of safety on the basis of maximum shear stress theory is ________ (round off to one decimal place).
GATE 2019 · Mechanical Engineering · Set 1 · IIT Madras · printed as Q.42 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
For the given in-plane stress state with , , and , the in-plane principal stresses are:
Thus, the three principal stresses are:
Since , the maximum shear stress is:
According to the Maximum Shear Stress Theory (Tresca criterion):
Substituting :
Answer: 1.8
Practise Design for Static Loading & Failure Theories
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Design for Static Loading & Failure Theories
- GATE 2016 ME Set 1 · Q48The principal stresses at a point inside a solid object are σ1 = 100 MPa, σ2 = 100 MPa and σ3 = 0 MPa. The…
- GATE 2014 ME Set 4 · Q40A shaft is subjected to pure torsional moment. The maximum shear stress developed in the shaft is 100 MPa.…
- GATE 2024 ME · Q56A solid massless cylindrical member of 50 mm diameter is rigidly attached at one end, and is subjected to an…
Question from the official GATE 2019 ME paper (Set 1), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.