GATE 2016 ME Set 2 · Question 62
The surface irregularities of electrodes used in an electrochemical machining (ECM) process are and as shown in the figure. If the work-piece is of pure iron and is applied between the electrodes, the largest feed rate is _________.
| Conductivity of the electrolyte | |
| :--- | :--- |
| Over-potential voltage | |
| Density of iron | |
| Atomic weight of iron | |
Assume the iron to be dissolved as and the Faraday constant to be .
GATE 2016 · Mechanical Engineering · Set 2 · IISc Bangalore · printed as Q.52 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
To avoid a short circuit between the electrodes, the minimum nominal gap must equal the sum of the peak surface irregularities:
The feed rate in electrochemical machining (ECM) based on Faraday's law is given by:
Given:
- Conductivity
- Effective voltage
- Atomic mass
- Density
- Valency
- Faraday's constant
Substituting these values to find the largest feed rate (corresponding to ):
Converting to :
Answer: 51.54
Practise Non-Traditional Machining (NTM) Processes
23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Non-Traditional Machining (NTM) Processes
- GATE 2016 ME Set 3 · Q32In a wire-cut EDM process the necessary conditions that have to be met for making a successful cut are that
- GATE 2015 ME Set 2 · Q31The primary mechanism of material removal in electrochemical machining (ECM) is
- GATE 2015 ME Set 2 · Q63A resistance-capacitance relaxation circuit is used in an electrical discharge machining process. The…
- GATE 2014 ME Set 2 · Q33The following four unconventional machining processes are available in a shop floor. The most appropriate…
- GATE 2014 ME Set 3 · Q28The process utilizing mainly thermal energy for removing material is
- GATE 2014 ME Set 4 · Q32The principle of material removal in Electrochemical machining is
Question from the official GATE 2016 ME paper (Set 2), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.