GATE 2016 ME Set 3 · Question 32
In a wire-cut EDM process the necessary conditions that have to be met for making a successful cut are that
- A
wire and sample are electrically non-conducting
- B
wire and sample are electrically conducting
- C
wire is electrically conducting and sample is electrically non-conducting
- D
sample is electrically conducting and wire is electrically non-conducting
GATE 2016 · Mechanical Engineering · Set 3 · IISc Bangalore · printed as Q.22 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
Electrical Discharge Machining (EDM), including Wire-cut EDM (WEDM), removes material by thermoelectric erosion caused by repeated electrical spark discharges across a dielectric-filled gap between the tool electrode (the wire) and the workpiece (the sample).
For an electrical discharge (spark) to occur and sustain the process:
1. The tool (wire) must act as one electrode.
2. The workpiece (sample) must act as the opposing electrode.
Therefore, both the wire and the sample must be electrically conducting. If either the wire or the sample is non-conducting, no spark can be generated, and material removal cannot take place.
Answer: (B) wire and sample are electrically conducting
Practise Non-Traditional Machining (NTM) Processes
23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Non-Traditional Machining (NTM) Processes
- GATE 2015 ME Set 2 · Q31The primary mechanism of material removal in electrochemical machining (ECM) is
- GATE 2015 ME Set 2 · Q63A resistance-capacitance relaxation circuit is used in an electrical discharge machining process. The…
- GATE 2014 ME Set 2 · Q33The following four unconventional machining processes are available in a shop floor. The most appropriate…
- GATE 2014 ME Set 3 · Q28The process utilizing mainly thermal energy for removing material is
- GATE 2014 ME Set 4 · Q32The principle of material removal in Electrochemical machining is
- GATE 2013 ME · Q38During the electrochemical machining (ECM) of iron (atomic weight = 56, valency = 2) at current of 1000 A…
Question from the official GATE 2016 ME paper (Set 3), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.