GATE 2016 ME Set 3 · Question 61
In a single point turning operation with cemented carbide tool and steel work piece, it is found that the Taylor's exponent is . If the cutting speed is reduced by then the tool life changes by ______ times.
GATE 2016 · Mechanical Engineering · Set 3 · IISc Bangalore · printed as Q.51 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
According to Taylor's tool life equation:
where is the cutting speed, is the tool life, and is the Taylor's exponent.
Given:
- Taylor's exponent,
- The cutting speed is reduced by , so
Using the relation :
Substitute the given values:
Thus, the tool life changes by times.
Answer: 16
Practise Tool Wear, Tool Life and Machinability
12 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Tool Wear, Tool Life and Machinability
- GATE 2015 ME Set 1 · Q33Under certain cutting conditions, doubling the cutting speed reduces the tool life to (1/16 )th of the…
- GATE 2014 ME Set 3 · Q33Cutting tool is much harder than the workpiece. Yet the tool wears out during the tool-work interaction,…
- GATE 2013 ME · Q34Two cutting tools are being compared for a machining operation. The tool life equations are: aligned Carbide…
- GATE 2026 ME · Q64A drill bit during its lifetime can produce 150 through holes in a plate at a drill-speed of 200 RPM. If the…
- GATE 2024 ME · Q60A cutting tool provides a tool life of 60 minutes while machining with the cutting speed of 60 m/min. When…
- GATE 2019 ME Set 1 · Q63Taylor's tool life equation is given by VTn = C, where V is in m/min and T is in min. In a turning…
Question from the official GATE 2016 ME paper (Set 3), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.