GATE 2016 ME Set 3 · Question 62
Two optically flat plates of glass are kept at a small angle as shown in the figure. Monochromatic light is incident vertically.
If the wavelength of light used to get a fringe spacing of is , the wavelength of light (in nm) to get a fringe spacing of is _______
GATE 2016 · Mechanical Engineering · Set 3 · IISc Bangalore · printed as Q.52 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
For an air-wedge formed between two optical flats inclined at a small angle , the fringe spacing obtained with normal incident monochromatic light is given by:
where is the wavelength of the light and is the wedge angle (in radians).
Since the wedge angle is constant:
Given:
Substitute the values:
Answer: 675
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2014 ME Set 1 · Q31Which one of the following instruments is widely used to check and calibrate geometric features of machine…
- GATE 2014 ME Set 2 · Q30The flatness of a machine bed can be measured using
- GATE 2014 ME Set 3 · Q63The diameter of a recessed ring was measured by using two spherical balls of diameter d2=60 mm and d1=40 mm…
- GATE 2013 ME · Q12A metric thread of pitch 2 mm and thread angle 60° is inspected for its pitch diameter using 3-wire method.…
- GATE 2026 ME · Q33A two-dimensional surface profile is obtained over a sampling length by using a contact type stylus…
- GATE 2023 ME · Q54A coordinate measuring machine (CMM) is used to determine the distance between Surface SP and Surface SQ of…
Question from the official GATE 2016 ME paper (Set 3), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.