GATE 2017 ME Set 2 · Question 50
A rod of length is stretched to make a rod of length . Subsequently, it is compressed to make a rod of final length . Consider the longitudinal tensile strain as positive and compressive strain as negative. The total true longitudinal strain in the rod is
- A
-0.5
- B
-0.69
- C
-0.75
- D
-1.0
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
True longitudinal strain is an additive state function dependent only on the initial length and the final length :
Given the initial length and the final length :
Step-by-step verification:
1. Tension from to :
2. Compression from to :
Options (A), (C), and (D) incorrectly use engineering strain formulas or algebraic differences.
Answer: (B) -0.69
Practise Simple Stress, Strain and Elastic Constants
22 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Simple Stress, Strain and Elastic Constants
- GATE 2016 ME Set 1 · Q42A horizontal bar with a constant cross-section is subjected to loading as shown in the figure. The Young's…
- GATE 2016 ME Set 2 · Q33The value of true strain produced in compressing a cylinder to half its original length is
- GATE 2016 ME Set 3 · Q30Engineering strain of a mild steel sample is recorded as 0.100%. The true strain is
- GATE 2016 ME Set 3 · Q43A square plate of dimension L × L is subjected to a uniform pressure load p = 250 MPa on its edges as shown…
- GATE 2015 ME Set 2 · Q17A rod is subjected to a uni-axial load within linear elastic limit. When the change in the stress is 200…
- GATE 2014 ME Set 1 · Q17A metallic rod of 500 mm length and 50 mm diameter, when subjected to a tensile force of 100 kN at the ends,…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.