GATE 2017 ME Set 2 · Question 7
1 markNumerical answerMechanics of MaterialsComplex Stresses, Plane Strain and Mohr's Circle
The state of stress at a point is and . The maximum normal stress (in MPa) at that point is ________
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
49.9 to 50.1
From the official answer key published by IIT Roorkee.
Worked solution
The given state of stress is a condition of pure shear in the -plane:
All other stress components in the -direction are zero ().
The in-plane principal stresses are given by:
Substituting the given values:
The principal stresses are , , and .
Thus, the maximum normal stress at the point is .
Answer: 50
Practise Complex Stresses, Plane Strain and Mohr's Circle
16 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Complex Stresses, Plane Strain and Mohr's Circle
- GATE 2016 ME Set 3 · Q18The state of stress at a point on an element is shown in figure (a). The same state of stress is shown in…
- GATE 2015 ME Set 2 · Q44In a plane stress condition, the components of stress at a point are σx = 20 MPa, σy = 80 MPa and τxy = 40…
- GATE 2014 ME Set 1 · Q40The state of stress at a point is given by σx = -6 MPa, σy = 4 MPa, and τxy = -8 MPa. The maximum tensile…
- GATE 2014 ME Set 2 · Q21A thin plate of uniform thickness is subject to pressure as shown in the figure below Under the assumption…
- GATE 2012 ME · Q34The state of stress at a point under plane stress condition is σxx = 40 MPa, σyy = 100 MPa and τxy = 40 MPa.…
- GATE 2026 ME · Q52A welded square plate of 1 m × 1 m is subjected to biaxial stress of magnitude 6.5 MPa and 25 MPa, as shown…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.