GATE 2017 ME Set 2 · Question 8
For a loaded cantilever beam of uniform cross-section, the bending moment (in ) along the length is , where is the distance (in mm) measured from the free end of the beam. The magnitude of shear force (in N) in the cross-section at is ________
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The relationship between the bending moment and the shear force at any section along the beam is:
The bending moment distribution is given as:
where is in and is in .
Differentiating with respect to :
Since has units of and has units of , the derivative directly yields the shear force in .
Substituting :
The magnitude of the shear force at is .
Answer: 110
Practise Shear Force and Bending Moment Diagrams
9 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Shear Force and Bending Moment Diagrams
- GATE 2015 ME Set 2 · Q41A cantilever beam OP is connected to another beam PQ with a pin joint as shown in the figure. A load of 10…
- GATE 2015 ME Set 3 · Q56For the overhanging beam shown in figure, the magnitude of maximum bending moment (in kN-m) is _______
- GATE 2013 ME · Q41A simply supported beam of length L is subjected to a varying distributed load (3π x / L) Nm-1, where the…
- GATE 2026 ME · Q40A cantilever beam of length L is subjected to a concentrated load P and a moment M as shown in the figure…
- GATE 2025 ME · Q57A simply supported beam of length 1 m is subjected to a uniformly distributed bending moment of 1 N m per m…
- GATE 2024 ME · Q41Which of the following beam(s) is/are statically indeterminate?
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.