GATE 2025 ME · Question 57
A simply supported beam of length is subjected to a uniformly distributed bending moment of throughout the length as shown in the figure given below. The bending moment at the mid-point of the beam is_______ (*rounded off to the nearest integer*).
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
Let the beam of length lie along the -axis from (support A) to (support B). The beam is subjected to a uniformly distributed counter-clockwise bending moment .
Taking moment equilibrium about support A:
From vertical equilibrium:
The internal bending moment at any cross-section at a distance from support A is obtained by considering the left segment:
Since for all , the bending moment at the mid-point () is:
Answer: 0
Practise Shear Force and Bending Moment Diagrams
9 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Shear Force and Bending Moment Diagrams
- GATE 2024 ME · Q41Which of the following beam(s) is/are statically indeterminate?
- GATE 2024 ME · Q53A horizontal beam of length 1200 mm is pinned at the left end and is resting on a roller at the other end as…
- GATE 2023 ME · Q39A beam of length L is loaded in the xy -plane by a uniformly distributed load, and by a concentrated tip…
- GATE 2017 ME Set 2 · Q8For a loaded cantilever beam of uniform cross-section, the bending moment (in N×mm) along the length is M(x)…
- GATE 2015 ME Set 2 · Q41A cantilever beam OP is connected to another beam PQ with a pin joint as shown in the figure. A load of 10…
- GATE 2015 ME Set 3 · Q56For the overhanging beam shown in figure, the magnitude of maximum bending moment (in kN-m) is _______
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.