GATE 2018 ME Set 2 · Question 41
A bar of circular cross section is clamped at ends P and Q as shown in the figure. A torsional moment is applied at a distance of from end P. The torsional reactions in Nm at the ends P and Q respectively are
- A
- B
- C
- D
GATE 2018 · Mechanical Engineering · Set 2 · IIT Guwahati · printed as Q.31 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
For a circular bar fixed at both ends and , the total angle of twist between the supports is zero:
Let the torsional reaction moments at ends and be and , respectively. For static equilibrium under the applied torque :
From the compatibility of deformation for uniform polar moment of inertia and shear modulus :
Given and :
Substituting into the equilibrium equation:
Thus, the torsional reactions are . The other options do not satisfy both static equilibrium and deformation compatibility.
Answer: (C)
Practise Torsion of Circular Shafts
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Torsion of Circular Shafts
- GATE 2017 ME Set 1 · Q15A motor driving a solid circular steel shaft transmits 40 kW of power at 500 rpm. If the diameter of the…
- GATE 2016 ME Set 1 · Q18The cross sections of two hollow bars made of the same material are concentric circles as shown in the…
- GATE 2016 ME Set 2 · Q17A shaft with a circular cross-section is subjected to pure twisting moment. The ratio of the maximum shear…
- GATE 2016 ME Set 2 · Q42A rigid horizontal rod of length 2L is fixed to a circular cylinder of radius R as shown in the figure.…
- GATE 2016 ME Set 3 · Q44Two circular shafts made of same material, one solid (S) and one hollow (H), have the same length and polar…
- GATE 2015 ME Set 1 · Q25Consider a stepped shaft subjected to a twisting moment applied at B as shown in the figure. Assume shear…
Question from the official GATE 2018 ME paper (Set 2), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.