PARIXO GATE · ME Open the app

GATE 2016 ME Set 1 · Question 18

1 markMultiple choiceMechanics of MaterialsTorsion of Circular Shafts

The cross sections of two hollow bars made of the same material are concentric circles as shown in the figure. It is given that and , and that the areas of the cross-sections are the same. and are the torsional rigidities of the bars on the left and right, respectively. The ratio is

Figure 1 for GATE 2016 ME Set 1 question 18
  1. A

  2. B

  3. C

  4. D

    between 0.5 and 1

GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.8 in the ME section

Answer
(A)

From the official answer key published by IISc Bangalore.

Worked solution

For a circular tube, the polar second moment of area is . Since the material is identical for both bars (same shear modulus ), the ratio of torsional rigidities is given by:

The cross-sectional areas are equal:

Factoring the difference of fourth powers:

Hence, the ratio is:

Since and , it directly follows that . Therefore,

Distributing the material farther from the axis of twist increases the torsional rigidity for the same cross-sectional area.

Answer: (A)

Practise Torsion of Circular Shafts

14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Torsion of Circular Shafts

Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.