GATE 2019 ME Set 1 · Question 57
Three slabs are joined together as shown in the figure. There is no thermal contact resistance at the interfaces. The center slab experiences a non-uniform internal heat generation with an average value equal to , while the left and right slabs have no internal heat generation. All slabs have thickness equal to and thermal conductivity of each slab is equal to . The two extreme faces are exposed to fluid with heat transfer coefficient and bulk temperature as shown. The heat transfer in the slabs is assumed to be one dimensional and steady, and all properties are constant. If the left extreme face temperature is measured to be , the right extreme face temperature is ________ .
GATE 2019 · Mechanical Engineering · Set 1 · IIT Madras · printed as Q.47 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
Under steady-state conditions, an overall energy balance on the three-slab composite wall equates the total heat generated to the total heat transferred by convection to the fluid from the two outer surfaces:
The total heat generated per unit surface area in the middle slab is:
The heat flux dissipated by convection from the left extreme face is given by Newton's law of cooling:
By energy conservation, the heat flux leaving through the right extreme face is:
Equating to convection at the right face:
Answer: 60
Practise Conduction with Internal Heat Generation
7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Conduction with Internal Heat Generation
- GATE 2017 ME Set 1 · Q38Heat is generated uniformly in a long solid cylindrical rod (diameter = 10 mm) at the rate of 4 × 107 W/m3.…
- GATE 2015 ME Set 2 · Q53A cylindrical uranium fuel rod of radius 5 mm in a nuclear reactor is generating heat at the rate of 4× 107…
- GATE 2013 ME · Q19Consider one-dimensional steady state heat conduction along x-axis (0 ≤ x ≤ L), through a plane wall with…
- GATE 2024 ME · Q48Consider a slab of 20 mm thickness. There is a uniform heat generation of q = 100 MW/m3 inside the slab. The…
- GATE 2022 ME Set 1 · Q45Consider a rod of uniform thermal conductivity whose one end (x = 0) is insulated and the other end (x = L)…
- GATE 2022 ME Set 2 · Q63Consider steady state, one-dimensional heat conduction in an infinite slab of thickness 2L (L = 1 m) as…
Question from the official GATE 2019 ME paper (Set 1), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.