GATE 2013 ME · Question 19
Consider one-dimensional steady state heat conduction along x-axis (), through a plane wall with the boundary surfaces ( and ) maintained at temperatures of and . Heat is generated uniformly throughout the wall. Choose the CORRECT statement.
- A
The direction of heat transfer will be from the surface at to the surface at .
- B
The maximum temperature inside the wall must be greater than .
- C
The temperature distribution is linear within the wall.
- D
The temperature distribution is symmetric about the mid-plane of the wall.
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
The 1D steady-state heat conduction equation with uniform internal heat generation and constant thermal conductivity is:
Integrating twice with boundary conditions and yields:
Because , the temperature curve has a downward concavity (parabolic, not linear, ruling out Option C). Due to asymmetric boundary temperatures, the profile cannot be symmetric about the mid-plane (ruling out Option D).
With internal heat generation, heat is generated within the domain and flows outward toward the boundaries. As a result, a local maximum occurs within the interior where , meaning the peak temperature inside the wall exceeds the higher surface temperature of .
Answer: (B) The maximum temperature inside the wall must be greater than .
Practise Conduction with Internal Heat Generation
7 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Conduction with Internal Heat Generation
- GATE 2024 ME · Q48Consider a slab of 20 mm thickness. There is a uniform heat generation of q = 100 MW/m3 inside the slab. The…
- GATE 2022 ME Set 1 · Q45Consider a rod of uniform thermal conductivity whose one end (x = 0) is insulated and the other end (x = L)…
- GATE 2022 ME Set 2 · Q63Consider steady state, one-dimensional heat conduction in an infinite slab of thickness 2L (L = 1 m) as…
- GATE 2019 ME Set 1 · Q57Three slabs are joined together as shown in the figure. There is no thermal contact resistance at the…
- GATE 2017 ME Set 1 · Q38Heat is generated uniformly in a long solid cylindrical rod (diameter = 10 mm) at the rate of 4 × 107 W/m3.…
- GATE 2015 ME Set 2 · Q53A cylindrical uranium fuel rod of radius 5 mm in a nuclear reactor is generating heat at the rate of 4× 107…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.