PARIXO GATE · ME Open the app

GATE 2019 ME Set 2 · Question 30

1 markNumerical answerEngineering MechanicsTrusses and Frames

The figure shows an idealized plane truss. If a horizontal force of is applied at point A, then the magnitude of the force produced in member CD is _____ N.

Figure 1 for GATE 2019 ME Set 2 question 30

GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.20 in the ME section

Answer
0

From the official answer key published by IIT Madras.

Worked solution

Consider the equilibrium of joints in the plane truss starting from joint A.

At joint A, two non-collinear members and meet, subjected to an external horizontal load of .

Next, examine joint B: only two members, and , meet at joint B (since line continues towards , let's check members at B: member , member , and member ).
Notice that joint B has members , (which are collinear) and horizontal member . Since no external load is applied at joint B, the equilibrium perpendicular to line gives:

Now consider joint C: members meeting at C are , (collinear along the right leg), , and the diagonal member .
Since , considering the equilibrium perpendicular to the line :

where is the angle between and the line ().

Therefore, the force in member is zero:

Answer: 0

Practise Trusses and Frames

21 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Trusses and Frames

Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.