GATE 2019 ME Set 2 · Question 47
A horizontal cantilever beam of circular cross-section, length and flexural rigidity is subjected to an applied moment at the free end as shown in the figure. The magnitude of the vertical deflection of the free end is _______ (round off to one decimal place).
GATE 2019 · Mechanical Engineering · Set 2 · IIT Madras · printed as Q.37 in the ME section
Answer
From the official answer key published by IIT Madras.
Worked solution
For a horizontal cantilever beam of length and flexural rigidity subjected to a concentrated bending moment at its free end, the deflection at the free end is given by:
Substitute the given values:
Answer: 2.5
Practise Deflection of Beams
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Deflection of Beams
- GATE 2016 ME Set 1 · Q19A cantilever beam having square cross-section of side a is subjected to an end load. If a is increased by…
- GATE 2016 ME Set 2 · Q43A simply supported beam of length 2L is subjected to a moment M at the mid-point x = 0 as shown in the…
- GATE 2016 ME Set 3 · Q45A beam of length L is carrying a uniformly distributed load w per unit length. The flexural rigidity of the…
- GATE 2015 ME Set 1 · Q54A cantilever beam with flexural rigidity of 200 N.m2 is loaded as shown in the figure. The deflection (in…
- GATE 2015 ME Set 2 · Q43A cantilever beam with square cross-section of 6 mm side is subjected to a load of 2 kN normal to the top…
- GATE 2014 ME Set 2 · Q40The flexural rigidity (EI) of a cantilever beam is assumed to be constant over the length of the beam shown…
Question from the official GATE 2019 ME paper (Set 2), IIT Madras. Solutions by PARIXO AI. All 65 questions of this paper.