GATE 2014 ME Set 2 · Question 40
The flexural rigidity () of a cantilever beam is assumed to be constant over the length of the beam shown in figure. If a load and bending moment are applied at the free end of the beam then the value of the slope at the free end is
- A
- B
- C
- D
GATE 2014 · Mechanical Engineering · Set 2 · IIT Kharagpur · printed as Q.30 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
By the principle of superposition, the slope at the free end of the cantilever beam is the sum of the slopes caused by the point load and the applied end moment .
1. Slope due to the concentrated downward load at the free end:
2. Slope due to the concentrated clockwise moment at the free end:
Since both the downward point load and the applied moment induce rotations in the same direction (clockwise):
Answer: (B)
Practise Deflection of Beams
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Deflection of Beams
- GATE 2014 ME Set 2 · Q41A cantilever beam of length, L, with uniform cross-section and flexural rigidity, EI, is loaded uniformly by…
- GATE 2014 ME Set 3 · Q45A force P is applied at a distance x from the end of the beam as shown in the figure. What would be the…
- GATE 2012 ME · Q22A cantilever beam of length L is subjected to a moment M at the free end. The moment of inertia of the beam…
- GATE 2023 ME · Q16The effective stiffness of a cantilever beam of length L and flexural rigidity EI subjected to a transverse…
- GATE 2021 ME Set 1 · Q27A cantilever beam of length, L, and flexural rigidity, EI, is subjected to an end moment, M, as shown in the…
- GATE 2021 ME Set 2 · Q63A cantilever beam with a uniform flexural rigidity (EI = 200 × 106 N.m2) is loaded with a concentrated force…
Question from the official GATE 2014 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.