GATE 2016 ME Set 1 · Question 19
A cantilever beam having square cross-section of side is subjected to an end load. If is increased by 19%, the tip deflection decreases approximately by
- A
19%
- B
29%
- C
41%
- D
50%
GATE 2016 · Mechanical Engineering · Set 1 · IISc Bangalore · printed as Q.9 in the ME section
Answer
From the official answer key published by IISc Bangalore.
Worked solution
The tip deflection of a cantilever beam of length subjected to an end point load is given by:
For a square cross-section of side , the area moment of inertia is:
Thus, the deflection is inversely proportional to :
When the side increases by , the new side is .
The new tip deflection becomes:
The percentage decrease in tip deflection is:
Answer: (D) 50%
Practise Deflection of Beams
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Deflection of Beams
- GATE 2016 ME Set 2 · Q43A simply supported beam of length 2L is subjected to a moment M at the mid-point x = 0 as shown in the…
- GATE 2016 ME Set 3 · Q45A beam of length L is carrying a uniformly distributed load w per unit length. The flexural rigidity of the…
- GATE 2015 ME Set 1 · Q54A cantilever beam with flexural rigidity of 200 N.m2 is loaded as shown in the figure. The deflection (in…
- GATE 2015 ME Set 2 · Q43A cantilever beam with square cross-section of 6 mm side is subjected to a load of 2 kN normal to the top…
- GATE 2014 ME Set 2 · Q40The flexural rigidity (EI) of a cantilever beam is assumed to be constant over the length of the beam shown…
- GATE 2014 ME Set 2 · Q41A cantilever beam of length, L, with uniform cross-section and flexural rigidity, EI, is loaded uniformly by…
Question from the official GATE 2016 ME paper (Set 1), IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.