GATE 2020 ME Set 1 · Question 15
The members carrying zero force (i.e. zero-force members) in the truss shown in the figure, for any load with no appreciable deformation of the truss (i.e. with no appreciable change in angles between the members), are
- A
BF and DH only
- B
BF, DH and GC only
- C
BF, DH, GC, CD and DE only
- D
BF, DH, GC, FG and GH only
GATE 2020 · Mechanical Engineering · Set 1 · IIT Delhi · printed as Q.5 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
We identify the zero-force members by analyzing the joints:
1. Joint B: Members and are collinear, and member meets them perpendicularly. With no external load at , equilibrium in the vertical direction gives:
2. Joint D: Members and are collinear, and member is perpendicular to them. With no external load at :
3. Joint G: Members and are collinear, and member is perpendicular. With no external load at :
4. Joint E: Member has horizontal run and vertical rise , so it makes an angle of with the horizontal. The roller support at is inclined at such that its reaction force acts purely along the line of member ( to the horizontal). Considering equilibrium at joint perpendicular to the line of member :
From joint , since , we also have:
Thus, the zero-force members are BF, DH, GC, CD, and DE.
Answer: (C) BF, DH, GC, CD and DE only
Practise Trusses and Frames
21 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Trusses and Frames
- GATE 2020 ME Set 1 · Q51The magnitude of reaction force at joint C of the hinge-beam shown in the figure is ________ kN *(round off…
- GATE 2019 ME Set 1 · Q48A truss is composed of members AB, BC, CD, AD and BD, as shown in the figure. A vertical load of 10 kN is…
- GATE 2019 ME Set 2 · Q30The figure shows an idealized plane truss. If a horizontal force of 300 N is applied at point A, then the…
- GATE 2016 ME Set 1 · Q41A two-member truss PQR is supporting a load W. The axial forces in members PQ and QR are respectively
- GATE 2016 ME Set 2 · Q44In the figure, the load P = 1 N, length L = 1 m, Young's modulus E = 70 GPa, and the cross-section of the…
- GATE 2015 ME Set 1 · Q26Two identical trusses support a load of 100 N as shown in the figure. The length of each truss is 1.0 m;…
Question from the official GATE 2020 ME paper (Set 1), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.