GATE 2021 ME Set 1 · Question 24
An infinitely long pin fin, attached to an isothermal hot surface, transfers heat at a steady rate of to the ambient air. If the thermal conductivity of the fin material is doubled, while keeping everything else constant, the rate of steady-state heat transfer from the fin becomes . The ratio is
- A
- B
2
- C
- D
GATE 2021 · Mechanical Engineering · Set 1 · IIT Bombay · printed as Q.14 in the ME section
Answer
From the official answer key published by IIT Bombay.
Worked solution
For an infinitely long pin fin with uniform cross-sectional area, the steady-state heat transfer rate is given by:
where:
- is the convective heat transfer coefficient
- is the perimeter
- is the thermal conductivity of the fin material
- is the cross-sectional area
- is the temperature difference between the fin base and the ambient air
Since all other parameters are held constant, the heat transfer rate is directly proportional to the square root of thermal conductivity:
When thermal conductivity is doubled ():
Answer: (A)
Practise Heat Transfer from Extended Surfaces (Fins)
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Heat Transfer from Extended Surfaces (Fins)
- GATE 2017 ME Set 2 · Q18The heat loss from a fin is 6 W. The effectiveness and efficiency of the fin are 3 and 0.75, respectively.…
- GATE 2012 ME · Q18Which one of the following configurations has the highest fin effectiveness?
- GATE 2026 ME · Q43A very long fin of a uniform square cross-section is replaced by another very long fin of a uniform circular…
Question from the official GATE 2021 ME paper (Set 1), IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.