GATE 2017 ME Set 2 · Question 18
The heat loss from a fin is . The effectiveness and efficiency of the fin are and , respectively. The heat loss (in W) from the fin, keeping the entire fin surface at base temperature, is ______
GATE 2017 · Mechanical Engineering · Set 2 · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
The efficiency of a fin () is defined as the ratio of the actual heat transferred by the fin () to the maximum possible heat transfer from the fin () that would occur if the entire fin surface were maintained at the base temperature ():
Given:
- Actual heat loss,
- Fin efficiency,
- Fin effectiveness, (not needed to find )
Rearranging the efficiency relation to find the heat loss when the entire fin surface is at the base temperature:
Answer: 8
Practise Heat Transfer from Extended Surfaces (Fins)
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Heat Transfer from Extended Surfaces (Fins)
- GATE 2012 ME · Q18Which one of the following configurations has the highest fin effectiveness?
- GATE 2026 ME · Q43A very long fin of a uniform square cross-section is replaced by another very long fin of a uniform circular…
- GATE 2021 ME Set 1 · Q24An infinitely long pin fin, attached to an isothermal hot surface, transfers heat at a steady rate of Q1 to…
Question from the official GATE 2017 ME paper (Set 2), IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.