GATE 2022 ME Set 1 · Question 18
A square threaded screw is used to lift a load by applying a force . Efficiency of square threaded screw is expressed as
- A
The ratio of work done by per revolution to work done by per revolution
- B
- C
- D
The ratio of work done by per revolution to work done by per revolution
GATE 2022 · Mechanical Engineering · Set 1 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
The mechanical efficiency of any machine or mechanism is defined as the ratio of useful work output to the total work input:
For a square-threaded power screw used to lift a load by applying an effort force :
- The useful work output per revolution is the work done in raising the load :
where is the lead (or pitch for a single-start screw).
- The work input per revolution is the work done by the applied force :
where is the effective radius at which force acts.
Therefore, the efficiency is the ratio of work done by per revolution to the work done by per revolution. Option (D) represents the reciprocal of efficiency, while options (B) and (C) represent mechanical advantage and its reciprocal rather than efficiency.
Answer: (A) The ratio of work done by per revolution to work done by per revolution
Practise Riveted & Bolted Joints
13 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Riveted & Bolted Joints
- GATE 2022 ME Set 1 · Q40A bracket is attached to a vertical column by means of two identical rivets U and V separated by a distance…
- GATE 2020 ME Set 1 · Q49A rectangular steel bar of length 500 mm, width 100 mm, and thickness 15 mm is cantilevered to a 200 mm…
- GATE 2018 ME Set 2 · Q18Pre-tensioning of a bolted joint is used to
- GATE 2017 ME Set 1 · Q19Consider the schematic of a riveted lap joint subjected to tensile load F, as shown below. Let d be the…
- GATE 2017 ME Set 2 · Q35A steel plate, connected to a fixed channel using three identical bolts A, B and C, carries a load of 6 kN…
- GATE 2016 ME Set 3 · Q48A bolted joint has four bolts arranged as shown in figure. The cross sectional area of each bolt is 25 mm2.…
Question from the official GATE 2022 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.