PARIXO GATE · ME Open the app

GATE 2022 ME Set 1 · Question 33

1 markNumerical answerManufacturing EngineeringNon-Traditional Machining (NTM) Processes

Electrochemical machining operations are performed with tungsten as the tool, and copper and aluminum as two different workpiece materials. Properties of copper and aluminum are given in the table below.

| Material | Atomic mass<br>(amu) | Valency | Density (g/cm) |
| :--- | :---: | :---: | :---: |
| Copper | 63 | 2 | 9 |
| Aluminum | 27 | 3 | 2.7 |

Ignore overpotentials, and assume that current efficiency is 100% for both the workpiece materials. Under identical conditions, if the material removal rate (MRR) of copper is 100 mg/s, the MRR of aluminum will be _______ mg/s *(round-off to two decimal places)*.

GATE 2022 · Mechanical Engineering · Set 1 · IIT Kharagpur

Answer
27 to 30

From the official answer key published by IIT Kharagpur.

Worked solution

According to Faraday's law of electrolysis, the mass removal rate (MRR) in electrochemical machining is given by:

where is the atomic mass, is the current, is the valency, and is Faraday's constant.

Under identical machining conditions, the current and current efficiency (100\%) remain the same for both materials:

For copper:

For aluminum:

Taking the ratio:

Given :

Answer: 28.57

Practise Non-Traditional Machining (NTM) Processes

23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Non-Traditional Machining (NTM) Processes

Question from the official GATE 2022 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.