GATE 2020 ME Set 2 · Question 19
The process, that uses a tapered horn to amplify and focus the mechanical energy for machining of glass, is
- A
electrochemical machining
- B
electrical discharge machining
- C
ultrasonic machining
- D
abrasive jet machining
GATE 2020 · Mechanical Engineering · Set 2 · IIT Delhi · printed as Q.9 in the ME section
Answer
From the official answer key published by IIT Delhi.
Worked solution
In Ultrasonic Machining (USM), high-frequency electrical energy is converted into ultrasonic mechanical vibrations using a magnetostrictive or piezoelectric transducer. A tapered horn (or sonotrode) is specifically designed and attached to the transducer to amplify the vibration amplitude and concentrate/focus the mechanical acoustic energy onto the tool.
The vibrating tool drives an abrasive slurry against the workpiece, causing micro-chipping via abrasive particle impact. This makes USM particularly well-suited for machining hard, brittle, and non-conductive materials such as glass, ceramics, and quartz.
- Electrochemical machining (ECM) and Electrical discharge machining (EDM) rely on electrical conductivity and do not use an acoustic horn.
- Abrasive jet machining (AJM) uses pressurized gas nozzles without a tapered vibration horn.
Answer: (C) ultrasonic machining
Practise Non-Traditional Machining (NTM) Processes
23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Non-Traditional Machining (NTM) Processes
- GATE 2019 ME Set 2 · Q35In an electrical discharge machining process, the breakdown voltage across inter electrode gap (IEG) is 200…
- GATE 2018 ME Set 1 · Q65An electrochemical machining (ECM) is to be used to cut a through hole into a 12 mm thick aluminum plate.…
- GATE 2018 ME Set 2 · Q26Metal removal in electric discharge machining takes place through
- GATE 2018 ME Set 2 · Q62A circular hole of 25 mm diameter and depth of 20 mm is machined by EDM process. The material removal rate…
- GATE 2017 ME Set 1 · Q22Match the processes with their characteristics. | Process | Characteristics | | :--- | :--- | | P:…
- GATE 2017 ME Set 2 · Q20Which one of the following statements is TRUE for the ultrasonic machining (USM) process?
Question from the official GATE 2020 ME paper (Set 2), IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.