GATE 2018 ME Set 1 · Question 65
An electrochemical machining (ECM) is to be used to cut a through hole into a thick aluminum plate. The hole has a rectangular cross-section, . The ECM operation will be accomplished in , with efficiency of . Assuming specific removal rate for aluminum as , the current (in A) required is \_\_\_\_\_\_\_\_\_ (correct to two decimal places).
GATE 2018 · Mechanical Engineering · Set 1 · IIT Guwahati · printed as Q.55 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
The total volume of material to be removed is calculated from the dimensions of the through hole:
The machining time is . Thus, the actual volumetric material removal rate () is:
In electrochemical machining (ECM), the volumetric removal rate is related to the current , current efficiency , and specific removal rate by:
Substituting the given values:
Answer: 968.99 (Acceptable range: 968.8 to 969.2)
Practise Non-Traditional Machining (NTM) Processes
23 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Non-Traditional Machining (NTM) Processes
- GATE 2018 ME Set 2 · Q26Metal removal in electric discharge machining takes place through
- GATE 2018 ME Set 2 · Q62A circular hole of 25 mm diameter and depth of 20 mm is machined by EDM process. The material removal rate…
- GATE 2017 ME Set 1 · Q22Match the processes with their characteristics. | Process | Characteristics | | :--- | :--- | | P:…
- GATE 2017 ME Set 2 · Q20Which one of the following statements is TRUE for the ultrasonic machining (USM) process?
- GATE 2016 ME Set 1 · Q33The non-traditional machining process that essentially requires vacuum is
- GATE 2016 ME Set 2 · Q35In an ultrasonic machining (USM) process, the material removal rate (MRR) is plotted as a function of the…
Question from the official GATE 2018 ME paper (Set 1), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.