GATE 2022 ME Set 2 · Question 50
A shaft of length is made of two materials, one in the inner core and the other in the outer rim, and the two are perfectly joined together (no slip at the interface) along the entire length of the shaft. The diameter of the inner core is and the external diameter of the rim is , as shown in the figure. The modulus of rigidity of the core and rim materials are and , respectively. It is given that and . When the shaft is twisted by application of a torque along the shaft axis, the maximum shear stress developed in the outer rim and the inner core turn out to be and , respectively. All the deformations are in the elastic range and stress-strain relations are linear. Then the ratio is _______ *(round off to 2 decimal places)*.
GATE 2022 · Mechanical Engineering · Set 2 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
For a composite shaft with no slip at the interface, both the inner core and the outer rim undergo the same angle of twist per unit length, .
The shear strain at any radial distance from the axis is:
From Hooke's law in shear, the shear stress at radius is:
The maximum shear stress occurs at the outermost radius of each respective material:
- For the inner core ():
- For the outer rim ():
Taking the ratio of the maximum shear stresses:
Given and :
Answer: 1.5
Practise Torsion of Circular Shafts
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Torsion of Circular Shafts
- GATE 2019 ME Set 1 · Q30A cylindrical rod of diameter 10 mm and length 1.0 m is fixed at one end. The other end is twisted by an…
- GATE 2018 ME Set 2 · Q30A hollow circular shaft of inner radius 10 mm, outer radius 20 mm and length 1 m is to be used as a…
- GATE 2018 ME Set 2 · Q41A bar of circular cross section is clamped at ends P and Q as shown in the figure. A torsional moment T =…
- GATE 2017 ME Set 1 · Q15A motor driving a solid circular steel shaft transmits 40 kW of power at 500 rpm. If the diameter of the…
- GATE 2016 ME Set 1 · Q18The cross sections of two hollow bars made of the same material are concentric circles as shown in the…
- GATE 2016 ME Set 2 · Q17A shaft with a circular cross-section is subjected to pure twisting moment. The ratio of the maximum shear…
Question from the official GATE 2022 ME paper (Set 2), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.