GATE 2023 ME · Question 27
Which of the plot(s) shown is/are valid Mohr’s circle representations of a plane stress state in a material? (The center of each circle is indicated by O.)
- A
M1
- B
M2
- C
M3
- D
M4
GATE 2023 · Mechanical Engineering · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
For any plane stress state with components , , and , the coordinates of the center of Mohr's circle on the plane are given by:
Because , the center of Mohr's circle must strictly lie on the normal stress axis.
- In M1, the center is at the origin , representing a state of pure shear (where ). This is a valid Mohr's circle.
- In M2 and M4, the center has a non-zero shear stress coordinate (), which is physically impossible.
- In M3, the center lies on the positive -axis with , which is a valid Mohr's circle.
Thus, only M1 and M3 are valid representations.
Answer: (A) M1; (C) M3
Practise Complex Stresses, Plane Strain and Mohr's Circle
16 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Complex Stresses, Plane Strain and Mohr's Circle
- GATE 2022 ME Set 2 · Q38A linear elastic structure under plane stress condition is subjected to two sets of loading, I and II. The…
- GATE 2020 ME Set 1 · Q17The stress state at a point in a material under plane stress condition is equi-biaxial tension with a…
- GATE 2019 ME Set 2 · Q31The state of stress at a point in a component is represented by a Mohr's circle of radius 100 MPa centered…
- GATE 2018 ME Set 1 · Q16If σ1 and σ3 are the algebraically largest and smallest principal stresses respectively, the value of the…
- GATE 2018 ME Set 1 · Q39The state of stress at a point, for a body in plane stress, is shown in the figure below. If the minimum…
- GATE 2018 ME Set 1 · Q41A carpenter glues a pair of cylindrical wooden logs by bonding their end faces at an angle of θ = 30° as…
Question from the official GATE 2023 ME paper, IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.