GATE 2018 ME Set 1 · Question 41
A carpenter glues a pair of cylindrical wooden logs by bonding their end faces at an angle of as shown in the figure.
The glue used at the interface fails if
Criterion 1: the maximum normal stress exceeds 2.5 MPa.
Criterion 2: the maximum shear stress exceeds 1.5 MPa.
Assume that the interface fails before the logs fail. When a uniform tensile stress of 4 MPa is applied, the interface
- A
fails only because of criterion 1
- B
fails only because of criterion 2
- C
fails because of both criteria 1 and 2
- D
does not fail
GATE 2018 · Mechanical Engineering · Set 1 · IIT Guwahati · printed as Q.31 in the ME section
Answer
From the official answer key published by IIT Guwahati.
Worked solution
Under a uniaxial tensile stress along the horizontal axis, the normal to the inclined interface makes an angle with the axis of the log.
The normal stress and shear stress acting on the interface are given by:
Comparing with the failure criteria:
1. Criterion 1 allows a maximum normal stress of . Since , it fails under Criterion 1.
2. Criterion 2 allows a maximum shear stress of . Since , it fails under Criterion 2.
Thus, the interface fails due to both criteria.
Answer: (C) fails because of both criteria 1 and 2
Practise Complex Stresses, Plane Strain and Mohr's Circle
16 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Complex Stresses, Plane Strain and Mohr's Circle
- GATE 2017 ME Set 1 · Q42A rectangular region in a solid is in a state of plane strain. The (x, y) coordinates of the corners of the…
- GATE 2017 ME Set 2 · Q7The state of stress at a point is σx = σy = σz = τxz = τzx = τyz = τzy = 0 and τxy = τyx = 50 MPa. The…
- GATE 2016 ME Set 3 · Q18The state of stress at a point on an element is shown in figure (a). The same state of stress is shown in…
- GATE 2015 ME Set 2 · Q44In a plane stress condition, the components of stress at a point are σx = 20 MPa, σy = 80 MPa and τxy = 40…
- GATE 2014 ME Set 1 · Q40The state of stress at a point is given by σx = -6 MPa, σy = 4 MPa, and τxy = -8 MPa. The maximum tensile…
- GATE 2014 ME Set 2 · Q21A thin plate of uniform thickness is subject to pressure as shown in the figure below Under the assumption…
Question from the official GATE 2018 ME paper (Set 1), IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.