GATE 2023 ME · Question 26
The principal stresses at a point P in a solid are , and . The yield stress of the material is . Which prediction(s) about material failure at P is/are CORRECT?
- A
Maximum normal stress theory predicts that the material fails
- B
Maximum shear stress theory predicts that the material fails
- C
Maximum normal stress theory predicts that the material does not fail
- D
Maximum shear stress theory predicts that the material does not fail
GATE 2023 · Mechanical Engineering · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The principal stresses are , , and . The yield strength is .
1. Maximum Normal Stress Theory (Rankine's Theory):
Failure occurs if:
Here, .
Hence, the material does not fail according to maximum normal stress theory (Option C is correct, Option A is incorrect).
2. Maximum Shear Stress Theory (Tresca's Theory):
Failure occurs if:
Substituting the principal stresses:
Since , the material fails according to maximum shear stress theory (Option B is correct, Option D is incorrect).
Answer: (B) Maximum shear stress theory predicts that the material fails; (C) Maximum normal stress theory predicts that the material does not fail
Practise Energy Methods and Theories of Failure
21 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Energy Methods and Theories of Failure
- GATE 2023 ME · Q59A cylindrical bar has a length L = 5 m and cross section area S = 10 m2. The bar is made of a linear elastic…
- GATE 2022 ME Set 1 · Q37An L-shaped elastic member ABC with slender arms AB and BC of uniform cross-section is clamped at end A and…
- GATE 2022 ME Set 2 · Q18A structural member under loading has a uniform state of plane stress which in usual notations is given by…
- GATE 2021 ME Set 2 · Q27The von Mises stress at a point in a body subjected to forces is proportional to the square root of the
- GATE 2021 ME Set 2 · Q41A plane frame PQR (fixed at P and free at R) is shown in the figure. Both members (PQ and QR) have length,…
- GATE 2020 ME Set 1 · Q38Bars of square and circular cross-section with 0.5 m length are made of a material with shear strength of 20…
Question from the official GATE 2023 ME paper, IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.