GATE 2023 ME · Question 55
A solid part (see figure) of polymer material is to be fabricated by additive manufacturing (AM) in square-shaped layers starting from the bottom of the part working upwards. The nozzle diameter of the AM machine is and the nozzle follows a linear serpentine path parallel to the sides of the square layers with a feed rate of .
Ignore any tool path motions other than those involved in adding material, and any other delays between layers or the serpentine scan lines.
The time taken to fabricate this part is ________ minutes.
*(Answer in integer)*
GATE 2023 · Mechanical Engineering · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The part is composed of three square-cross-section blocks stacked vertically:
- Bottom block: base , height
- Middle block: base , height
- Top block: base , height
The nozzle diameter is and the feed rate is .
To compute the total fabrication time, the number of layers in each section is required:
If one assumes the layer thickness equals the nozzle diameter , the total number of layers for each section would be:
- Bottom: layers
- Middle: layers
- Top: layers
However, the layer thickness was not explicitly specified in the problem statement. Because fabrication time depends directly on the slice/layer thickness, the question was invalidated and marks were awarded to all candidates.
Answer: Marks to all (the question was dropped)
Practise NC/CNC Machines, CAD/CAM and Additive Manufacturing
30 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from NC/CNC Machines, CAD/CAM and Additive Manufacturing
- GATE 2022 ME Set 1 · Q19A CNC worktable is driven in a linear direction by a lead screw connected directly to a stepper motor. The…
- GATE 2022 ME Set 1 · Q28Which of the following additive manufacturing technique(s) can use a wire as a feedstock material?
- GATE 2022 ME Set 2 · Q21Match the additive manufacturing technique in Column I with its corresponding input material in Column II. |…
- GATE 2022 ME Set 2 · Q22Which one of the following CANNOT impart linear motion in a CNC machine?
- GATE 2021 ME Set 1 · Q19In modern CNC machine tools, the backlash has been eliminated by
- GATE 2021 ME Set 1 · Q51The XY table of a NC machine tool is to move from P(1,1) to Q(51,1); all coordinates are in mm. The pitch of…
Question from the official GATE 2023 ME paper, IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.