GATE 2023 ME · Question 54
A coordinate measuring machine (CMM) is used to determine the distance between Surface SP and Surface SQ of an approximately cuboidal shaped part. Surface SP is declared as the datum as per the engineering drawing used for manufacturing this part. The CMM is used to measure four points P1, P2, P3, P4 on Surface SP, and four points Q1, Q2, Q3, Q4 on Surface SQ as shown. A regression procedure is used to fit the necessary planes.
The distance between the two fitted planes is ________ mm.
*(Answer in integer)*
GATE 2023 · Mechanical Engineering · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
The coordinate measuring machine (CMM) measures points on the datum surface and surface .
For the datum surface , the measured points are:
All points have a -coordinate of . Hence, the fitted datum plane is the plane:
Since surface is designated as the primary datum, the plane fitted to surface is constrained to be parallel to the datum plane , having the equation:
The measured points on surface are:
Using least-squares regression, the best-fit constant is the mean of the -coordinates:
The perpendicular distance between the two parallel planes and is:
Answer: 5
Practise Linear, Angular, Form & Surface Metrology
15 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Linear, Angular, Form & Surface Metrology
- GATE 2023 ME · Q56An optical flat is used to measure the height difference between a reference slip gauge A and a slip gauge…
- GATE 2022 ME Set 2 · Q56The best size wire is fitted in a groove of a metric screw such that the wire touches the flanks of the…
- GATE 2021 ME Set 1 · Q20Consider the surface roughness profile as shown in the figure. The center line average roughness (Ra, in μm)…
- GATE 2021 ME Set 2 · Q52A 76.2 mm gauge block is used under one end of a 254 mm sine bar with roll diameter of 25.4 mm. The height…
- GATE 2020 ME Set 2 · Q22The figure below shows a symbolic representation of the surface texture in a perpendicular lay orientation…
- GATE 2020 ME Set 2 · Q42Two rollers of diameters D1 (in mm) and D2 (in mm) are used to measure the internal taper angle in the…
Question from the official GATE 2023 ME paper, IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.