GATE 2024 ME · Question 53
A horizontal beam of length is pinned at the left end and is resting on a roller at the other end as shown in the figure. A linearly varying distributed load is applied on the beam. The magnitude of maximum bending moment acting on the beam is _______ . *(round off to 1 decimal place)*
GATE 2024 · Mechanical Engineering · IISc Bangalore
Answer
From the official answer key published by IISc Bangalore.
Worked solution
For a simply supported beam of length subjected to a linearly varying load with :
The total load is:
Taking moments about the right support to find the left reaction :
The shear force at any section from the left end is:
The maximum bending moment occurs where :
The maximum bending moment is:
Rounding off to one decimal place gives .
Answer: 9.2
Practise Shear Force and Bending Moment Diagrams
9 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Shear Force and Bending Moment Diagrams
- GATE 2023 ME · Q39A beam of length L is loaded in the xy -plane by a uniformly distributed load, and by a concentrated tip…
- GATE 2017 ME Set 2 · Q8For a loaded cantilever beam of uniform cross-section, the bending moment (in N×mm) along the length is M(x)…
- GATE 2015 ME Set 2 · Q41A cantilever beam OP is connected to another beam PQ with a pin joint as shown in the figure. A load of 10…
- GATE 2015 ME Set 3 · Q56For the overhanging beam shown in figure, the magnitude of maximum bending moment (in kN-m) is _______
- GATE 2013 ME · Q41A simply supported beam of length L is subjected to a varying distributed load (3π x / L) Nm-1, where the…
- GATE 2026 ME · Q40A cantilever beam of length L is subjected to a concentrated load P and a moment M as shown in the figure…
Question from the official GATE 2024 ME paper, IISc Bangalore. Solutions by PARIXO AI. All 65 questions of this paper.