GATE 2023 ME · Question 39
A beam of length is loaded in the by a uniformly distributed load, and by a concentrated tip load parallel to the , as shown in the figure. The resulting bending moment distributions about the and the axes are denoted by and , respectively.
Which one of the options given depicts qualitatively CORRECT variations of and along the length of the beam?
- A
See figure (A)
- B
See figure (B)
- C
See figure (C)
- D
See figure (D)
GATE 2023 · Mechanical Engineering · IIT Kanpur
Answer
From the official answer key published by IIT Kanpur.
Worked solution
Consider a section at distance from the fixed support () and take the free portion of the beam from to :
1. Moment about the -axis ():
The concentrated load acts at the tip () parallel to the direction. The moment caused by about the centroidal -axis of the section is:
This varies linearly with , having a maximum positive value at the fixed support and dropping to at the free end .
2. Moment about the -axis ():
The uniformly distributed load acts in the direction over the entire span. The moment about the -axis at the section is:
This varies quadratically (parabolically) with , having a negative value at and reaching at .
Plot (B) correctly depicts a positive linear variation for and a negative parabolic variation for .
Answer: (B) See figure (B)
Practise Shear Force and Bending Moment Diagrams
9 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Shear Force and Bending Moment Diagrams
- GATE 2017 ME Set 2 · Q8For a loaded cantilever beam of uniform cross-section, the bending moment (in N×mm) along the length is M(x)…
- GATE 2015 ME Set 2 · Q41A cantilever beam OP is connected to another beam PQ with a pin joint as shown in the figure. A load of 10…
- GATE 2015 ME Set 3 · Q56For the overhanging beam shown in figure, the magnitude of maximum bending moment (in kN-m) is _______
- GATE 2013 ME · Q41A simply supported beam of length L is subjected to a varying distributed load (3π x / L) Nm-1, where the…
- GATE 2026 ME · Q40A cantilever beam of length L is subjected to a concentrated load P and a moment M as shown in the figure…
- GATE 2025 ME · Q57A simply supported beam of length 1 m is subjected to a uniformly distributed bending moment of 1 N m per m…
Question from the official GATE 2023 ME paper, IIT Kanpur. Solutions by PARIXO AI. All 65 questions of this paper.