GATE 2025 ME · Question 63
Cylindrical workpieces of diameter and length are machined on a lathe at a cutting speed of and a feed of . The Taylor’s tool life parameters and for this setup are and , respectively. The tool changing time is . With a labor and overhead cost of ₹ , the tool changing cost per piece is ₹ \_\_\_\_\_\_ (*rounded off to 2 decimal places*).
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
Given:
- Diameter,
- Length,
- Cutting speed,
- Feed,
- Tool life equation:
- Tool changing time,
- Labor and overhead rate,
From Taylor's tool life equation:
Spindle speed:
Machining time per piece:
Tool changing time per piece:
Tool changing cost per piece:
Answer: 2.79
Practise Economics of Machining
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Economics of Machining
- GATE 2020 ME Set 2 · Q55Bars of 250 mm length and 25 mm diameter are to be turned on a lathe with a feed of 0.2 mm/rev. Each…
- GATE 2016 ME Set 2 · Q61For a certain job, the cost of metal cutting is Rs. 18C/V and the cost of tooling is Rs. 270C/(TV), where C…
- GATE 2014 ME Set 1 · Q64If the Taylor's tool life exponent n is 0.2, and the tool changing time is 1.5 min, then the tool life (in…
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.