GATE 2014 ME Set 1 · Question 64
2 marksNumerical answerManufacturing EngineeringEconomics of Machining
If the Taylor's tool life exponent is , and the tool changing time is , then the tool life (in ) for maximum production rate is _______
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.54 in the ME section
Answer
5.9 to 6.1
From the official answer key published by IIT Kharagpur.
Worked solution
For maximum production rate (minimum production time), the optimum tool life depends on Taylor's tool life exponent and the tool change time through the relation:
Given:
Substituting these values:
Answer: 6
Practise Economics of Machining
4 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Economics of Machining
- GATE 2025 ME · Q63Cylindrical workpieces of diameter 60 mm and length 400 mm are machined on a lathe at a cutting speed of 25…
- GATE 2020 ME Set 2 · Q55Bars of 250 mm length and 25 mm diameter are to be turned on a lathe with a feed of 0.2 mm/rev. Each…
- GATE 2016 ME Set 2 · Q61For a certain job, the cost of metal cutting is Rs. 18C/V and the cost of tooling is Rs. 270C/(TV), where C…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.