GATE 2026 ME · Question 21
A rectangular plate is perfectly welded to a gusset plate with parallel fillet weld joints as shown in the figure below. The length of the weld is and the fillet weld leg size is . The allowable shear strength of the weldment is . A tensile force is applied on the plate in a direction parallel to the length of the weld. Assuming the throat of the weld as the weakest section, the critical load is
- A
- B
- C
- D
GATE 2026 · Mechanical Engineering · IIT Guwahati
Answer
From the official answer key published by IIT Guwahati.
Worked solution
The joint consists of two parallel fillet welds, each of length and leg size . The throat thickness of a standard fillet weld is given by:
The total throat area resisting the parallel shear load across the two welds is:
Assuming the throat is the weakest section, the critical load that the joint can carry without exceeding the allowable shear strength is:
Options (A) and (D) only account for a single weld or use an incorrect throat geometry without considering both sides.
Answer: (C)
Practise Welded Joints
5 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welded Joints
- GATE 2025 ME · Q61Two plates of thickness 10 mm each are to be joined by a transverse fillet weld on one side and the…
- GATE 2021 ME Set 1 · Q65A cantilever beam of rectangular cross-section is welded to a support by means of two fillet welds as shown…
- GATE 2014 ME Set 4 · Q65A butt weld joint is developed on steel plates having yield and ultimate tensile strength of 500 MPa and 700…
- GATE 2012 ME · Q32A fillet welded joint is subjected to transverse loading F as shown in the figure. Both legs of the fillets…
Question from the official GATE 2026 ME paper, IIT Guwahati. Solutions by PARIXO AI. All 65 questions of this paper.