GATE 2012 ME · Question 44
A force of is applied to the brake drum of diameter in a band-brake system as shown in the figure, where the wrapping angle is . If the coefficient of friction between the drum and the band is 0.25, the braking torque applied, in is
- A
100.6
- B
54.4
- C
22.1
- D
15.7
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
For a band brake, the relation between the tensions in the tight side () and slack side () is:
Given wrapping angle and coefficient of friction :
With the drum rotating clockwise, the band tension increases in the direction of rotation (from the fixed anchor at the bottom to the pulled end at the top), making the top band the tight side:
The braking torque applied to the drum of radius is:
Answer: (B)
Practise Brakes & Clutches
12 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Brakes & Clutches
- GATE 2024 ME · Q59A band brake shown in the figure has a coefficient of friction of 0.3. The band can take a maximum force of…
- GATE 2023 ME · Q34The braking system shown in the figure uses a belt to slow down a pulley rotating in the clockwise direction…
- GATE 2021 ME Set 1 · Q63A short shoe drum (radius 260 mm) brake is shown in the figure. A force of 1 kN is applied to the lever. The…
- GATE 2020 ME Set 1 · Q47In a disc-type axial clutch, the frictional contact takes place within an annular region with outer and…
- GATE 2019 ME Set 1 · Q54A single block brake with a short shoe and torque capacity of 250 N×m is shown. The cylindrical brake drum…
- GATE 2019 ME Set 2 · Q52A short shoe external drum brake is shown in the figure. The diameter of the brake drum is 500 mm. The…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.