GATE 2013 ME · Question 52
Statement for Linked Answer Questions 52 and 53:
In orthogonal turning of a bar of diameter with a feed of , depth of cut of and cutting velocity of , it is observed that the main (tangential) cutting force is perpendicular to the friction force acting at the chip-tool interface. The main (tangential) cutting force is .
The orthogonal rake angle of the cutting tool in is
- A
zero
- B
3.58
- C
5
- D
7.16
GATE 2013 · Mechanical Engineering · IIT Bombay
Answer
From the official answer key published by IIT Bombay.
Worked solution
In orthogonal machining, the main (tangential) cutting force acts along the direction of the cutting velocity vector .
The friction force acts along the tool rake face as the chip slides over it.
By definition, the orthogonal rake angle is the angle between the tool rake face and the plane perpendicular to the cutting velocity direction. Consequently, the angle between the cutting velocity vector (the line of action of ) and the rake face (the line of action of ) is:
It is given that is perpendicular to , meaning :
Thus, the orthogonal rake angle of the tool is zero degrees.
Answer: (A) zero
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2013 ME · Q53Statement for Linked Answer Questions 52 and 53: In orthogonal turning of a bar of 100 mm diameter with a…
- GATE 2012 ME · Q27Details pertaining to an orthogonal metal cutting process are given below. | | | |---|---| | Chip thickness…
- GATE 2026 ME · Q63During orthogonal turning by using a single point cutting tool, feed rate is 0.24 mm/rev. The uncut chip…
- GATE 2023 ME · Q44In an ideal orthogonal cutting experiment (see figure), the cutting speed V is 1 m/s, the rake angle of the…
- GATE 2022 ME Set 1 · Q54Under orthogonal cutting condition, a turning operation is carried out on a metallic workpiece at a cutting…
- GATE 2022 ME Set 1 · Q55A 1 mm thick cylindrical tube, 100 mm in diameter, is orthogonally turned such that the entire wall…
Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.