GATE 2022 ME Set 1 · Question 55
A thick cylindrical tube, in diameter, is orthogonally turned such that the entire wall thickness of the tube is cut in a single pass. The axial feed of the tool is and the specific cutting energy () of the tube material is
. Neglect contribution of feed force towards power. The power required to carry out this operation is _______ *(round off to one decimal place)*.
GATE 2022 · Mechanical Engineering · Set 1 · IIT Kharagpur
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In orthogonal turning (end-turning) of a thin-walled cylindrical tube:
- Tube diameter
- Wall thickness
- Axial feed velocity
The cross-sectional area of the cut is the annular area:
The material removal rate (MRR) is:
Given the specific cutting energy and neglecting the power contribution from the feed force, the cutting power required is:
Answer: 31.4
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2022 ME Set 2 · Q55In an orthogonal machining operation, the cutting and thrust forces are equal in magnitude. The uncut chip…
- GATE 2021 ME Set 1 · Q48An orthogonal cutting operation is performed using a single point cutting tool with a rake angle of 12° on a…
- GATE 2021 ME Set 2 · Q50In a pure orthogonal turning by a zero rake angle single point carbide cutting tool, the shear force has…
- GATE 2020 ME Set 1 · Q55In a turning process using orthogonal tool geometry, a chip length of 100 mm is obtained for an uncut chip…
- GATE 2020 ME Set 2 · Q53A cylindrical bar with 200 mm diameter is being turned with a tool having geometry 0° - 9° - 7° - 8° - 15° -…
- GATE 2019 ME Set 1 · Q45In orthogonal turning of a cylindrical tube of wall thickness 5 mm, the axial and the tangential cutting…
Question from the official GATE 2022 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.