PARIXO GATE · ME Open the app

GATE 2013 ME · Question 53

2 marksMultiple choiceManufacturing EngineeringMechanics of Orthogonal Metal Cutting

Statement for Linked Answer Questions 52 and 53:

In orthogonal turning of a bar of diameter with a feed of , depth of cut of and cutting velocity of , it is observed that the main (tangential) cutting force is perpendicular to the friction force acting at the chip-tool interface. The main (tangential) cutting force is .

The normal force acting at the chip-tool interface in is

  1. A

    1000

  2. B

    1500

  3. C

    2000

  4. D

    2500

GATE 2013 · Mechanical Engineering · IIT Bombay

Answer
(B)

From the official answer key published by IIT Bombay.

Worked solution

The friction force acts along the tool rake face, while the normal force acts perpendicular to the rake face. The angle between the cutting direction (the direction of the tangential force ) and the rake face is , where is the orthogonal rake angle.

Since the main (tangential) cutting force is perpendicular to the friction force :

From Merchant's force relations:

Substituting and :

Answer: (B) 1500

Practise Mechanics of Orthogonal Metal Cutting

27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.

More from Mechanics of Orthogonal Metal Cutting

Question from the official GATE 2013 ME paper, IIT Bombay. Solutions by PARIXO AI. All 65 questions of this paper.