GATE 2012 ME · Question 27
Details pertaining to an orthogonal metal cutting process are given below.
| | |
|---|---|
| Chip thickness ratio | 0.4 |
| Undeformed thickness | |
| Rake angle | |
| Cutting speed | |
| Mean thickness of primary shear zone | |
The shear strain rate in during the process is
- A
- B
- C
- D
GATE 2012 · Mechanical Engineering · IIT Delhi
Answer
No official key survives for this paper; this is PARIXO AI's own answer, not official.
Worked solution
The shear angle is obtained using the chip thickness ratio and rake angle :
The shear velocity is given by:
With cutting speed and :
The shear strain rate is the ratio of shear velocity to the mean thickness of the primary shear zone :
Answer: (C)
Practise Mechanics of Orthogonal Metal Cutting
27 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Mechanics of Orthogonal Metal Cutting
- GATE 2026 ME · Q63During orthogonal turning by using a single point cutting tool, feed rate is 0.24 mm/rev. The uncut chip…
- GATE 2023 ME · Q44In an ideal orthogonal cutting experiment (see figure), the cutting speed V is 1 m/s, the rake angle of the…
- GATE 2022 ME Set 1 · Q54Under orthogonal cutting condition, a turning operation is carried out on a metallic workpiece at a cutting…
- GATE 2022 ME Set 1 · Q55A 1 mm thick cylindrical tube, 100 mm in diameter, is orthogonally turned such that the entire wall…
- GATE 2022 ME Set 2 · Q55In an orthogonal machining operation, the cutting and thrust forces are equal in magnitude. The uncut chip…
- GATE 2021 ME Set 1 · Q48An orthogonal cutting operation is performed using a single point cutting tool with a rake angle of 12° on a…
Question from the official GATE 2012 ME paper, IIT Delhi. Solutions by PARIXO AI. All 65 questions of this paper.