GATE 2014 ME Set 1 · Question 35
In solid-state welding, the contamination layers between the surfaces to be welded are removed by
- A
alcohol
- B
plastic deformation
- C
water jet
- D
sand blasting
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.25 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
In solid-state welding processes (such as friction welding, cold pressure welding, and roll bonding), coalescence is produced at temperatures below the melting point of the base metals without the addition of brazing or soldering filler metal.
For metallic bonding to occur, nascent (clean) metal surfaces must come into intimate atomic contact (within distances of a few angstroms). The tenacious oxide, absorbed gas, and contaminant films naturally present on metal surfaces are brittle compared to the underlying metal. When intense plastic deformation is applied at the interface, these brittle surface contaminant layers break up and disperse into the bulk, allowing fresh virgin metal to extrude through the cracks and form a solid-state metallurgical bond.
Solvent cleaning (like alcohol) or mechanical methods (like sand blasting) only clean macroscopic dirt but cannot achieve the atomic-level cleanliness required during the bonding step itself.
Answer: (B) plastic deformation
Practise Welding II: Resistance Welding, Solid-State Joining and Allied Processes
11 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Welding II: Resistance Welding, Solid-State Joining and Allied Processes
- GATE 2014 ME Set 3 · Q65For spot welding of two steel sheets (base metal) each of 3 mm thickness, welding current of 10000 A is…
- GATE 2013 ME · Q11Match the CORRECT pairs. | Processes | Characteristics / Applications | | :--- | :--- | | P. Friction…
- GATE 2025 ME · Q21The welding process commonly used for fabricating tailor-welded blanks of dissimilar thickness for…
- GATE 2023 ME · Q23Two surfaces P and Q are to be joined together. In which of the given joining operation(s), there is no…
- GATE 2021 ME Set 1 · Q47The resistance spot welding of two 1.55 mm thick metal sheets is performed using welding current of 10000 A…
- GATE 2021 ME Set 2 · Q48A spot welding operation performed on two pieces of steel yielded a nugget with a diameter of 5 mm and a…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.