GATE 2014 ME Set 1 · Question 47
An offset slider-crank mechanism is shown in the figure at an instant. Conventionally, the Quick Return Ratio (QRR) is considered to be greater than one. The value of QRR is
GATE 2014 · Mechanical Engineering · Set 1 · IIT Kharagpur · printed as Q.37 in the ME section
Answer
From the official answer key published by IIT Kharagpur.
Worked solution
Given dimensions:
- Crank radius
- Connecting rod length
- Offset
The extreme positions of the slider occur when the crank and connecting rod are collinear:
1. Extended position (crank and rod inline, length ):
2. Overlapped position (crank folded over rod, length ):
The angle between the two extreme positions is:
The working stroke crank angle is .
The Quick Return Ratio (QRR ) is:
Answer: 1.25
Practise Planar Mechanisms, Mobility and Inversions
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Planar Mechanisms, Mobility and Inversions
- GATE 2014 ME Set 2 · Q18A 4-bar mechanism with all revolute pairs has link lengths lf = 20 mm, lin = 40 mm, lco = 50 mm and lout =…
- GATE 2013 ME · Q23A planar closed kinematic chain is formed with rigid links PQ = 2.0 m, QR = 3.0 m, RS = 2.5 m and SP = 2.7 m…
- GATE 2025 ME · Q60An offset slider-crank mechanism is shown in the figure below. The length of the stroke of the slider is…
- GATE 2022 ME Set 1 · Q38A planar four-bar linkage mechanism with 3 revolute kinematic pairs and 1 prismatic kinematic pair is shown…
- GATE 2021 ME Set 1 · Q62The Whitworth quick return mechanism is shown in the figure with link lengths as follows: OP = 300 mm, OA =…
- GATE 2020 ME Set 1 · Q18A four bar mechanism is shown below. For the mechanism to be a crank-rocker mechanism, the length of the…
Question from the official GATE 2014 ME paper (Set 1), IIT Kharagpur. Solutions by PARIXO AI. All 65 questions of this paper.