GATE 2025 ME · Question 60
An offset slider-crank mechanism is shown in the figure below. The length of the stroke of the slider is ________ (*rounded off to nearest integer*).
GATE 2025 · Mechanical Engineering · IIT Roorkee
Answer
From the official answer key published by IIT Roorkee.
Worked solution
For an offset slider-crank mechanism with crank radius , connecting rod length , and offset , the extreme positions of the slider occur when the crank and connecting rod become collinear.
1. At the outer dead center (farthest position), the crank and connecting rod are aligned in extension:
2. At the inner dead center (nearest position), the crank folds back onto the connecting rod:
The length of the stroke is the distance between these extreme positions:
Rounding off to the nearest integer gives .
Answer: 62
Practise Planar Mechanisms, Mobility and Inversions
14 GATE questions from this chapter, in short untimed sets, with the formula sheet beside them. Free.
More from Planar Mechanisms, Mobility and Inversions
- GATE 2022 ME Set 1 · Q38A planar four-bar linkage mechanism with 3 revolute kinematic pairs and 1 prismatic kinematic pair is shown…
- GATE 2021 ME Set 1 · Q62The Whitworth quick return mechanism is shown in the figure with link lengths as follows: OP = 300 mm, OA =…
- GATE 2020 ME Set 1 · Q18A four bar mechanism is shown below. For the mechanism to be a crank-rocker mechanism, the length of the…
- GATE 2020 ME Set 2 · Q18The number of qualitatively distinct kinematic inversions possible for a Grashof chain with four revolute…
- GATE 2018 ME Set 1 · Q18For an Oldham coupling used between two shafts, which among the following statements are correct? I.…
- GATE 2018 ME Set 1 · Q30A four bar mechanism is made up of links of length 100, 200, 300 and 350 mm. If the 350 mm link is fixed,…
Question from the official GATE 2025 ME paper, IIT Roorkee. Solutions by PARIXO AI. All 65 questions of this paper.